Juniper JN0-522 인증시험

지금 같은 정보시대에, 많은 IT업체 등 사이트에Juniper JN0-522인증관련 자료들이 제공되고 있습니다, 하지만 이런 사이트들도 정확하고 최신 시험자료 확보는 아주 어렵습니다. 그들의Juniper JN0-522자료들은 아주 기본적인 것들뿐입니다. 전면적이지 못하여 응시자들의 관심을 쌓지 못합니다.

ITExamDump는 IT인증자격증을 취득하려는 IT업계 인사들의 검증으로 크나큰 인지도를 가지게 되었습니다. 믿고 애용해주신 분들께 감사의 인사를 드립니다. Juniper JN0-522덤프도 다른 과목 덤프자료처럼 적중율 좋고 통과율이 장난이 아닙니다. 덤프를 구매하시면 퍼펙트한 구매후 서비스까지 제공해드려 고객님이 보유한 덤프가 항상 시장에서 가장 최신버전임을 약속해드립니다. Juniper JN0-522덤프만 구매하신다면 자격증 취득이 쉬워져 고객님의 밝은 미래를 예약한것과 같습니다.

IT인증자격증만 소지한다면 일상생활에서 많은 도움이 될것입니다. 하지만 문제는 어떻게 간단하게 시험을 패스할것인가 입니다. ITExamDump는 IT전문가들이 제공한 시험관련 최신 연구자료들을 제공해드립니다.ITExamDump을 선택함으로써 여러분은 성공도 선택한것이라고 볼수 있습니다. ITExamDump의Juniper 인증JN0-522시험대비 덤프로Juniper 인증JN0-522시험을 패스하세요.

시험 번호/코드: JN0-522
시험 이름: Juniper (FXV,Associate (JNCIA-FWV))

Juniper JN0-522인증시험은 전문적인 관련지식을 테스트하는 인증시험입니다. ITExamDump는 여러분이Juniper JN0-522인증시험을 통과할 수 잇도록 도와주는 사이트입니다. 여러분은 응시 전 저희의 문제와 답만 잘 장악한다면 빠른 시일 내에 많은 성과 가 있을 것입니다.

ITExamDump는 믿을 수 있는 사이트입니다. IT업계에서는 이미 많이 알려져 있습니다. 그리고 여러분에 신뢰를 드리기 위하여 Juniper 인증JN0-522 관련자료의 일부분 문제와 답 등 샘플을 무료로 다운받아 체험해볼 수 있게 제공합니다. 아주 만족할 것이라고 믿습니다. ITExamDump제품에 대하여 아주 자신이 있습니다. Juniper 인증JN0-522 도 여러분의 무용지물이 아닌 아주 중요한 자료가 되리라 믿습니다. 여러분께서는 아주 순조로이 시험을 패스하실 수 있을 것입니다.

JN0-522 덤프무료샘플다운로드하기: http://www.itexamdump.com/jn0-522.html

NO.1 Click the Exhibit button. In the exhibit, if host A initiates a Web browsing session with host D, and the
E0/1 interface of the SSG 20 is in NAT mode, what will be the source address of the packet arriving at
host D?
A.10.1.1.1
B.10.1.10.5
C.143.45.56.1
D.143.45.56.254
Answer:C

Juniper   JN0-522   JN0-522자료

NO.2 Click the Exhibit button. In the exhibit, which routing command would allow host A to communicate with
host C? (Note: Assume a route from the SSG 20 to host A's subnet already exists.)
A.set route 0.0.0.0/0 int e0/3 gateway 177.11.56.254
B.set route 1.1.70.0 interface e0/3 gateway 177.11.56.254
C.configure route 1.1.70.0/24 gateway 177.11.56.254 int e0/3
D.set route 1.1.70.0/24 interface e0/3 gateway 177.11.56.254
Answer:D

Juniper   JN0-522자격증   JN0-522 dump

NO.3 Your VPN tunnel does not pass traffic. You run the get ike cookie command and discover that there is no
cookie. Which two should be verified? (Choose two.)
A.routes
B.Phase 1 configuration options
C.Phase 2 configuration options
D.selected quick mode encryption algorithms
Answer:A B

Juniper dump   JN0-522 pdf   JN0-522자료   JN0-522   JN0-522

NO.4 What needs to be configured in Phase 2 of a route-based VPN, that does not need to be configured in a
policy-based VPN?
A.proxy-id
B.tunnel-binding
C.transport mode
D.custom proposals
Answer:B

Juniper   JN0-522최신덤프   JN0-522

NO.5 Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D

Juniper   JN0-522   JN0-522최신덤프   JN0-522

NO.6 Which ScreenOS CLI command would be used to view traffic logs?
A.get traffic
B.get log policy
C.get policy log
D.get log traffic
Answer:D

Juniper dump   JN0-522 dump   JN0-522

NO.7 Assuming factory default settings, which statement describes the minimum requirements for WebUI
management access to the SSG 5?
A.Connect a PC addressed on the 192.168.1.0 subnet to any interface, open a browser and access
192.168.1.1.
B.Terminate the bootup sequence from the console device, open a browser on the console device and
access 192.168.1.1.
C.Connect a PC addressed on the 192.168.1.0 subnet, to the highest numbered interface and open a
browser and access 192.168.1.1.
D.Using the CLI, define an IP address on a physical interface, connect a PC to the interface and open a
browser to the interface address.
Answer:C

Juniper   JN0-522   JN0-522 dump   JN0-522기출문제

NO.8 You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C

Juniper pdf   JN0-522   JN0-522기출문제   JN0-522

NO.9 What are two benefits of configuring a ScreenOS device in transparent mode? (Choose two.)
A.There is no need to reconfigure the IP addresses of routers or protected servers.
B.There is no need to create MIPs or VIPs for incoming traffic to reach protected servers.
C.Policies are easier to create since you do not have to include source and destination IP addresses.
D.The product can support more VPNs and obtain greater throughput because there is less overhead to
manage.
Answer:A B

Juniper   JN0-522덤프   JN0-522   JN0-522

NO.10 Which statement is correct about tunnel interfaces?
A.They can have overlapping IP addresses.
B.They need to be configured in the zone where the protected resources reside.
C.They can be unnumbered and used in policy-based translations if the interface is in route mode.
D.They can be unnumbered from any interface residing on the same virtual router as the protected
resources.
Answer:D

Juniper   JN0-522   JN0-522   JN0-522덤프

NO.11 Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B

Juniper   JN0-522 dumps   JN0-522

NO.12 What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A

Juniper최신덤프   JN0-522자격증   JN0-522시험문제   JN0-522

NO.13 Which ScreenOS CLI policy statement keyword would enable a policy only during specified times, days,
and/or dates?
A.at
B.calendar
C.schedule
D.scheduler
Answer:C

Juniper시험문제   JN0-522자격증   JN0-522 dumps   JN0-522   JN0-522자료

NO.14 Click the Exhibit button. In the exhibit, which two forms of address translation would have generated
the output shown? (Choose two.)
A.MIP
B.NAT-src with no DIP
C.Interface-based translation
D.NAT-src with a DIP, fixed-port disabled
Answer:B C

Juniper시험문제   JN0-522   JN0-522

NO.15 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.255
How many MIP address translations have you just configured?
A.1
B.8
C.128
D.256
Answer:A

Juniper   JN0-522   JN0-522   JN0-522덤프

NO.16 What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D

Juniper기출문제   JN0-522자료   JN0-522   JN0-522

NO.17 Click the Exhibit button. In the exhibit, what is the correct command to configure a default route on the
SSG 20?
A.set route 0.0.0.0/0 vrouter untrust
B.set route 0.0.0.0/0 interface e0/4 gateway 143.45.56.254
C.set route 0.0.0.0/0 interface e0/4 next-hop 143.45.56.254
D.set route 0.0.0.0/0 interface 143.45.56.1 gate 143.45.56.254
Answer:B

Juniper pdf   JN0-522 dump   JN0-522기출문제   JN0-522   JN0-522최신덤프

NO.18 Click the Exhibit button. Traffic from the Internet to the partner servers must use a VIP. In the exhibit,
what is true about the configuration of this feature?
A.You cannot use a VIP in this environment.
B.The VIP can be configured on the e0/4 interface.
C.The VIP can be configured in the Corporate or Internet zone using a different subnet than the physical
interface.
D.The VIP will work only if the destination ports in the incoming packet headers are mapped to the same
ports in the Corporate zone.
Answer:A

Juniper   JN0-522자격증   JN0-522자격증

NO.19 Click the Exhibit button. In the exhibit, what is the correct address book entry for host C?
A.set address C 1.1.70.250/32
B.set address Partner C 1.1.70.250
C.set address Partner 1.1.70.250/32
D.set address Partner C 1.1.70.250/32
Answer:D

Juniper   JN0-522자격증   JN0-522

NO.20 Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A

Juniper인증   JN0-522최신덤프   JN0-522인증

Juniper JN0-522인증시험은 전업적지식이 강한 인증입니다. IT업계에서 일자리를 찾고 계시다면 많은 회사에서는Juniper JN0-522있는지 없는지에 알고 싶어합니다. 만약Juniper JN0-522자격증이 있으시다면 여러분은 당연히 경쟁력향상입니다.